F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999
Page 5 - 11
Operations
d) Press RESET at the rear of the machine on the
drive side Please refer to Figure 5.2.2
Figure 5.2.2 RESET
Reset
Rear of the laminator
INFORMATION
Once RESET has been engaged, power will
be restored, Laminating rollers will reset to
1 in. GAP and the display will return to it's
default settings.
Default mode; TOP TEMP. = 68
o
F ( 20
o
C ),
BOT. TEMP. = 68 oF ( 20 oC ), GAP = 1 in.,
PRESSURE = no bars are solid, JOB = 0, no
motion direction selected, SPEED = 00.0 and
SLEEP = flashing
e) Enter the desired operating parameters or
select the job number prior to the emergency
stop situation.
f) You may now resume operating the laminator.
5.3 Set up
Initial set up of the Falcon 160 laminator is
easily attained when instructions are followed exactly. It
is suggested and helpful if you take the time to read this
section thoroughly before attempting to do any of the
steps.A complete understanding of this section will
enable you to follow the procedures descibed in
Section 6.1 Application.
5.3.1 Power
a) Clear the area around the laminating rollers and
pull rollers nip..
b) Make sure the laminator is plugged in.
c) Turn the MAIN POWER to the “ON”
position.
P o w e r
