Safety
F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999
Page 1 - 8
INFORMATION
Notice that the footswitch speed is not
indicated in the SPEED DISPLAY on the
front control panel.
1.4 Operations
The following symbols are positioned at
various points in Section 5 Operations.
INFORMATION
Read the following warnings and cautions
before attempting to operate or service the
Falcon 160 Laminator.
INFORMATION
When any command is pressed on the
control panel, a "beep" will sound. If the
command is held down, the panel will
"beep" only once.
INFORMATION
When adjusting the pressure, the gap
will be affected as well.
W A R N I N G
Keep hands and fingers clear of
the laminator roller nip when
a d j u s t i n g P R E S S U R E .
Y o u c a n b e C R U S H E D o r B U R N E D !
INFORMATION
When the safety shield is in the lowered
position and "Footswitch" mode is engaged,
speed is controlled through the control
panel.
INFORMATION
If the variable speed footswitch is not
close to the speed of the control panel,
output quality may be affected by the
speed difference.
W A R N I N G
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
