F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999
Page 5 - 13
Operations
e) Push the clevis pin back down to secure the
unwind shaft its saddle.
f) Now you must center the roll of laminate on the
unwind shaft. Refer to Figure 5.3.3 for
measurements. For centering measurements,
refer to Figure 5.5.4.
g) For the lower unwind shaft, repeat steps “b”
through “f” again.
Figure 5.3.3 Centering the roll
Measure from
the side frame
to the edge of
the roll of
laminate.
Make sure
the laminate
is flush with
the core.
h) Close the rear safety shield when finished.
Figure 5.3.4 Measurement chart
Common film widths
12 "
28 "
24 "
22 "
31 "
18.5 "
37 "
15.5 "
41 "
15 "
47 "
13.5 "
49 "
10.5 "
51 "
9.5 "
55 "
8.5 "
58 "
6.5 "
60 "
5 "
62 "
4 "
38 "
3 "
Film width
Measurement
INFORMATION
For the lower unwind shaft, add 1/4 in. to
t h e m e a s u r e m e n t .
5.3.5 Heating
Perform the following steps.if the application
requires heat. Allow the rolls to heat up while rotating
for even heat disbursement.
