Page 6 - 3
Applications
F 60 C Operation and Maintenance Manual
© April 2001 General Binding Corporation
6.2 Charts and diagrams
Process control charts allow you to record the
way you thread film through the machine’s rollers and idlers
(called webbing) and the control settings for each prod-
uct and process. Process control charts are an excellent
tool for training new operators. They provide a “road
map” for correct machine setup and operation.
This section contains a blank process control chart
and diagram for the Falcon 60 C as well as completed
charts for the basic operations of the laminator. The pro-
cess control charts should be kept in this manual or in a
book close to the laminator.
The Falcon 60 C laminator responds in a very
accurate and repeatable manner. The charts provide a
way to set up each time, every time for repeatable per-
formance by assuring that all controls are set to optimum.
The completed process control charts included
in this section are based on GBC films, GBC boards and
typical prints. Charts and diagrams start on page 6-4. If
your machine is equipped with the roll to roll option, web-
bing diagrams for related applications are also included.
