GBC 2064WF-1
Operation Manual
© 2009 General Binding Corporation an ACCO Brands CO. Page 11
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7
Rear Media Table:
The
Rear
Media Table
(Fig.4A) is used to
position items for Lamination. There are two
media tables on the machine one on the front &
one on the rear of the Laminator.
Table Safety Interlock Switch:
The
Table Safety Interlock Switch
(Fig.4B)
ensures that the table is properly placed and
secure. The
Safety Interlock Switch
will not
allow the Laminator to operate at full speed unless
the tables are properly installed.
Optical Safety System:
The
Optical Safety System
(Fig. 5A&6A) utilizes
2 optical beams located at the Main Roll Nip as
well as the Pull Roll Nip. Once the Optical Eye is
blocked, the machine will instantly stop unless the
operator is using the Foot Switch. While using the
Foot Switch and the Optical Eye is blocked, the
machine will only operate at a fixed speed of
3ft/mn. Please refer to the Sequence of Operation.
Main Rollers:
The 2
Main Rollers
(Fig.5 B&C) are used to
apply Heat and Pressure to films being used.
Silicone rubber coated steel tubes heat the
laminating film and compresses the heated film to
the items being laminated. Heat is provided by an
internal heating element.
Pull Rollers:
The
Pull Rollers
(Fig.6 B&C) located at the back
of the laminator are motor driven and the lower
roller is clutched. They simultaneously pull the
film and image.
Rewind Tubes:
The
Rewind Tubes
(Fig.7A) are used to rewind
release liners or finished Medias.
Upper Tension Idler:
(Fig.7B)
The Upper Tension Idler Guides the upper
lamination onto the Top Main Roller insuring a
constant amount of wrap on the Top Main Roller.
