GBC 4064WF
Operation Manual
© 2005 General Binding Corporation
Page 15
OPERATING INSTRUCTIONS
Po
ly-i
n
Ad
he
siv
e
su
rfa
ce
Polyester surface
Po
ly-o
ut
Ad
he
siv
e
su
rfa
ce
Polyester surface
1
5
2
3
4
6
=
Film Loading & Threading
The top and bottom rolls of laminating film must be of the
same width and be present simultaneously. A Small amount
of adhesive will “squeeze out” during Lamination.
Hardened adhesive deposits can damage the heat rollers.
CAUTION:
Adhesive will deposit on the rollers if:
•
Only one roll is used.
•
Different widths of rolls are loaded together.
•
Either roll is loaded adhesive side against a heat roller.
•
One or both rolls of film are allowed to run completely
off its core.
The adhesive side of the film is on the inner side of the web
(Fig. 16 A and B). The shiny side of clear film must contact
the heat rollers. The dull side of the film contains the
adhesive. Use extreme caution when loading delustered
(matte) film as both sides appear dull.
Always change the top and bottom supply rolls at the same
time. Near the end of each roll of GBC laminating film is a
label stating “Warning-End of Roll”. The appearance of this
label on either the top or bottom roll requires that new rolls
of film be installed as soon as the item presently being
laminated completely exits the rear of the laminator.
Do not introduce any additional items into the laminator
when the warning label is visible.
To load a roll of film:
(Fig. 17)
1.
Pull the swing out shaft clevis pin up.
2.
Swing shaft outward.
3.
Slide the roll of film onto the film shaft ensuring
Adhesive side is out.
4.
Push the film shaft back into the film shaft Support
saddle.
5.
Push the clevis pin down.
6.
Center the roll of film.
Figure 16
Figure 17
A
B
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
