Page 5 - 20
Operations
© GBC Films Group January 2001
Orbit™ 2000 Operation and Maintenance Manual
Overlap adjustment
W A R N I N G
WARNING: Only person(s) trained in all aspects of the equipment may
perform any operator adjustments.
W A R N I N G
C A U T I O N : N E V E R T U R N T H E D I A L ( t ) W H E N T H E M A C H I N E I S S T O P P E D !
For each paper size, the speed of the feeding head must be adjusted. This is done by manually
turning the dial pointer ( u ) located below the control panel.
Steps
1/
Set the machine to its lowest running speed.
2/
Start the machine.
3/
Set the dial pointer ( u ) to a value
just short of the sheet length. ( ie. a 17 in.
sheet, set the dial to 16.5 in. )
4/
Check the overlap.
5/
Should you require a shorter overlap, turn the dial pointer ( u ) slightly toward the “larger sheet
size” direction.
6/
Should you require a longer overlap, turn the dial pointer ( u ) slightly toward the “shorter sheet
size” direction.
7/
After turning the dial pointer ( u ), always wait for 2 to 4 sheets, before continuing with the
adjustments. The variator has a slight delay.
u
