Operations
Page 5 - 11
Orca 1600 Operation and Maintenance Manual
© GBC Films Group February 2001
Unloading a roll of film
a) Cut the laminate from the web.
C A U T IO N
D o n ot use an open blad e to cut
the w eb near the rollers.
Y ou can put cu ts into th e rollers!
b) Pull up on the clevis pin.
c) Swing the unwind shaft out away from the
laminator.
( U p p e r u n w in d s h a ft s h o w n fo r illu s tra tio n p u rp o s e s )
d) With a little twist on the roll of film, pull the
roll off of the unwind arm.
e) If finished, swing the unwind arm back into
its unwind support saddle and push the clevis
pin down. If not, follow the Load a roll of
film procedure again from step d).
5.7 Main roller nip
To set the main roller nip for use with
substrates can easily be obtained by setting the shim
dials on the main roller to the desired opening.
a) Ensure the upper main roller is in the up
position.
T he n ip can on ly be changed w ith the
upper roller in the up position.
IN F O R M A T IO N
b) Turn the shim dial to the desired setting.
F ro n t o p e ra tin g p o s itio n
S h im d ia ls
( vie w e d fro m th e to p o f la m in a to r )
c) Adjust main roller pressure for the desired
setting with respect to the substrate being used.
d) Press the main roller UP/ DOWN switch to
DOWN.
