GBC Ricoh StreamPunch MP, Installation Manual

Ricoh StreamPunch Pro, Pro EX & MP Installation Manual

                                                    8 

 6. Leveling & Height Adjustment 

6.1 Height Setting 

No height adjustment of the StreamPunch is required, for an installation site with a level floor, when 
docking upstream of the SR4050, SR5020, SK5010 or SR5030. If the floor is uneven then it is 
recommended to set the level of the StreamPunch using the downstream device as a reference. The exit 
guide of the StreamPunch should be set as shown below for the various finisher types. When installing 
the StreamPunch upstream of the SK5000, the StreamPunch will need to be lowered by approximately 
5mm. Follow the same adjustment procedure as in Section 6.2 and use the table below for a reference 
height. 

Finisher 

Reference Height X   

Finisher 

Reference Height Y 

SR5000 

4mm SK5010

2.5mm 

SR4050/SR4080 

4mm 

SR5020 

3mm 

SR5030/ SR5040 

3mm 

SK5000* 

2.5mm 

* Height adjustment required 

 
6.2 Adjusting the Casters 

a)  

Using a 9/16” (15mm) open ended wrench, loosen 
the jam nut(s) situated on the caster stud inside of 
the machine

. 

b)  

Using the 9/16” (15mm) wrench, rotate the caster 
stems to change the height. 

Re-tighten the jam nuts once the correct height is 
achieved.

X 

StreamPunch  

Output 

Downstream 
Device Input 

Downstream 
Device Input

StreamPunch  

Output

Y