Operations Manual
Page 31
T
ALON
44/64
CE
©2004 General Binding Corporation
Applications
Tips for Pre-coating Boards
(Figure 37)
1.
Load the laminator as illustrated in Figure 37.
2.
Ensure the chill idler is in the rest position.
3.
Set the roller pressure handle to the correct thick-
ness.
4.
The width of the roll should not exceed the width of
the board by more than 1/2 in. (1.3 cm).
5.
Use a leader board to start the run and a trailer board
to finish the run.
6.
Using the pull rollers will allow you to leave gaps
between boards.
7.
If not using the pull rollers, have the boards nearby to
butt end to end during feeding.
Tips for using the rear rollers
(Figure 38)
1.
If the front rollers are heated, you may perform certain
applications from the rear operating position of the
laminator.
2.
Ensure the chill idler is in the rest position if using
boards.
3. Ensure the safety shield is located in the rear
position.
4.
Ensure the
REAR CONTROLS
have been enabled.
5.
You may perform mounting applications, pre-coating
applications and single side applications from the rear
of the machine.
Tips for Mounting Pre-coated Boards
(Figure 39)
1.
Load the laminator as illustrated in Figure 39.
2.
Ensure the, the rear slitter is to one side and the inline
slitter is not obstructing the path of the boards.
3.
Heat, 125 °F (52 °C), may assist the process and
increase output quality.
4.
Do not stop once you have started the mounting
process through the machine.
Fig 37
Fig 38
Board
Liner
Fig 39
Summary of Contents for Talon 44 CE
