4. Installation
Service
WARNING:
Do not attempt to service or repair
the laminator. Failure to observe this warning could
result in severe personal injury or death.
Disconnect the plug from the receptacle and contact
GBC Technical Service when one or more of the
following has occurred.
•
The power supply cord or attachment plug is
damaged.
•
Liquid has been spilled into the laminator.
•
The laminator is malfunctioning after being
mishandled.
•
The laminator does not operate as described in
these instructions.
Installation
•
Shipping damage should be brought to the
immediate attention of the delivering carrier.
•
Place the laminator on a stable flat surface
capable of supporting 150 lbs.
•
The surface should be at least 30” high to
assure comfortable positioning during
operation. All four rubber feet should be on the
supporting surface.
•
Connect power cord to an appropriate power
source. Avoid connecting other equipment to
the same branch circuit to which the laminator
is connected as this may cause nuisance
tripping of the circuit breaker or blown fuses.
•
The laminator should be positioned to allow
exiting film to drop freely to the floor.
Accumulation of laminate as it exits the
laminator may cause film to wrap around the
rollers, causing a jammed condition.
•
Avoid placing laminator near sources of heat or
cold. Avoid locating the laminator in the direct
path of forced, heated or cooled air.
Caring for Ultima 65
The only maintenance required by the operator is to
periodically clean the rollers. Keeping the rollers clean
ensures that your finished items will not be damaged by
dirt and adhesive build-ups.
CAUTION:
the following procedure is performed
while the laminator is hot. Use extreme caution.
WARNING:
Do not apply cleaning fluids or
solvents to the rollers.
WARNING:
Do not attempt to laminate
adhesives marked ‘Flammable’.
WARNING:
Do not expose laminator to liquids.
1.
Remove the film from the laminator following the
procedure outlined in the section FILM LOADING
AND THREADING.
2.
Clean the top and bottom rollers with a clean,
damp lint-free cloth. If there are any adhesive
build-ups, you may use isopropyl alcohol instead of
water.
3.
To remove difficult debris Preheat the laminator
until the READY LAMP (
) illuminates.
4.
Push and hold the SLOW Backward button to
rotate the upper and lower rollers with the safety
shield open.
5.
Follow the procedure in section FILM LOADING
AND THREADING, Method Using Film Threading
Card to reload the laminator.
Note:
Do not use metal scouring pads to clean the heat
rollers!
Note:
Covering machine when not in use will reduce
dust build-up on the rollers and film which can lead to
poor lamination quality.
WARNING:
Do not laminate glitter and/or
metallic items. Damage to the rollers may result.
The side covers and feed table can be cleaned with a
lint-free cloth and a mild detergent.
