OR
2A4
2B
Alarm disabled
(default adjustment)
Press
2
then
#
OK
=
+ 2 Beeps
Error
= 3 Beeps
Green LED
OK
=
+ 2 Beeps
Error
= 3 Beeps
Green LED
3
Yellow LED
OR
Blue
LED
11.3 - MAX.NUMBER OF WRONG ATTEMPTS ALARM
11.4 - ANTI-TAMPERING ALARM
After 10 wrong attempts of Card/Tag reading or wrong entering
of PIN code, the keypad will block and any attempt will not be
possible for 10 minutes. The Doorbell button mode will be enabled
even if the alarm is working.
Interruption of the alarm when you close again the reader-keypad
and by the reading of a Card/Tag or a valide PIN code.
2A1
2A1
2A2
2A2
2A3
Alarm enabled
.
Press
1
then
#
Anti-tampering alarm enabled
Press
1
then
#
Enter the alarm duration from
1 to 300 sec., then press
#
Enter the duration of the alarm
from 1 to 300 sec, then press
#
The device must be in Programming mode, see Chap. 7
The device must be in Programming mode, see Chap. 7
1
1
Yellow LED
Yellow LED
7 3
(enables the function)
7 4
(enables the function)
OK
= Green LED
+ 1 Beep
OK
= Green LED
+ 1 Beep
LED / Audible beep
LED / Audible Beep
Buttons
Buttons
OK
=
+ 1 Beep
Error
= 3 Beeps
Green LED
OK
=
+ 1 Beep
Error
= 3 Beeps
Green LED
OK
=
+ 1 Beep
Error
= 3 Beeps
Green LED
(a)
The alarm output works only when the device is powered
in DC
Buzzer:
1
= Enabled /
2
= Disabled
(during the alarm) then press
#
(a)
Alarm output :
1
= Enabled /
2
= Disabled (during the alarm)
then press
#
Enter another function or press
to exit from Programming mode
