OPERATING INSTRUCTIONS
Temperature setting and operation
Under the use of electric fireplace, touch
or
, if the temperature shown on digital
display is greater than the environmental temperature, heater will be turned on, hot air will start
blowing; if temperature shown on digital display is less than the environmental temperature,
heater will not turn on, but fan will turn and blow cold air for a while and then stop. Touch
or
, the digital display will blink, desired temperature can be adjusted between
60-97
, each time they are touched, temperature will increase or decrease by 1
, temperature
on the digital display will blink several seconds and stop, then desired temperature is
automatically set. Holding
or
will continuously increase or decrease the
temperature to reach your desired temperature faster.
After turning on the electric fireplace by pressing
, touching
,
,
or
will turn on the heater; however, when the detector detects the environmental temperature is
greater than or equal to your desired temperature, heater will stop. When environmental
temperature descend and is lower than the desired temperature, heater will start working after a
while, and it will not stop until the environmental temperature is reached desired temperature.
IMPORTANT
Under the condition that the default setting of desired temperature is 77
, there are 2 possibility:
1. When the insert detects the environment temp. lower than 77
, the heater will begin to work
at high heat status automatically.
2. When the insert detects the environment temp. higher than 77
, the heater will first blow cold
air for a few seconds, and then stop.
from 77
to be higher than the environment temp(this will show on
the display panel when the power is turned on).
NOTE: Default setting of desired temperature is 77
. If the environmental temperature is
greater than 77
, heater will not turn on, only cold air will blow; if the environmental
temperature is less than 77
, heater will turn on and start blowing hot air.
REMINDER: When the environmental temperature is greater than 97
, heater will stop
immediately.
Timer setting
Under the condition when the electric fireplace is turned on, press
to switch to timer
setting mode. Time on digital display will blink. Press
or
to adjust the hour, which
will be the time for heater to work and heater will be automatically turned off beyond the hours
you set. When the desired time is determined, the digital display will blink for a few seconds,
then the time is automatically set. Holding
or
, time will continuously to go up or
down so that you may reach your desired hour faster.
To cancel timer, press
or
till the digital display show "0 .0H".
REMINDER:
a. When time reaches 10 hour, then press
, time increase by 1 hour from 10:00, 11:00,
to 12:00.
b. When time reaches 12 hour, then press
, time decrease by 1 hour from 12:00, 11:00,
to 10:00.
14