Page 7 of 28
M434/500 Prototype Commissioning Manual
PN W453101Rev- Nov-02-1998
Miscellaneous Data
The following checks are for Main Boom Head Sheave Radius and Swing Offset.
Swing Offset is negative when the boom pivot is behind the center of rotation.
Enter the measured values into the gray boxes provided.
Installation checks
Before continuing, make sure any necessary changes to geometrical data found in the previous
pages have been made to the capacity chip file and a new capacity chip has been created and
installed.
Check wiring and EPROM installations.
If swing switches are fitted, check that these operate correctly, by using the digital input monitor routine
through the MicroGuard display.
Set the reeling Drum Clutch
Boom Hoist Cylinder
Boom
Boom Pivot
Swing Offset
Hd Shv radius
Top Sheave
Head Sheave
Center of Rotation
