Guangcheng Technology
GC-4602 user manual
1. Functional introduction
1.1 Functional Overview
GC-4602 (2-channel analog output module,-5V~+5V) can be used to output
signals within the range of-5V~+5V. The terminal module can provide an
electrical isolation signal with a resolution of 16 bits for the processing layer.
The GC-4602 module has two two-wire outputs, which are particularly suitable
for installation in the control cabinet to save space. The GC-4602 module has a
common ground potential and the power contacts are connected together. The
reference ground of the output is 0V power contact.
1.2 Performance characteristics
●
The number of output points is 2;
●
The signal voltage is from -5V to 5V;
●
It is powered by GC-bus;
●
The load is more than 5k Ω (short circuit protection);
●
The measurement error is less than ±0.1% (full range);
●
The measurement resolution is 16 bits;
●
The conversion time is about 4ms;
●
The electrical isolation is 1500 Vrms (GC-bus/ signal voltage);
●
The current consumption of GC-bus is 150mA;
●
The bit width output in the resume process image is 2x 2 bytes;
●
The configuration has no address setting and is configured through a bus
coupler or controller;
●
This is suitable for all GCAN-PLC-400 series and GCAN-8000 series bus
terminal modules;
●
Working temperature range: -40
℃
~ + 85
℃
;
●
Size: long 100mm * wide 69mm * high 12mm.
1.3 Typical application
●
The standard analog signal can be output according to the instruction;
●
It can be used to adjust the opening of valves, gates and other control
equipment.
●
Connect to the bus coupler or controller to realize the transmission of analog
signals.
