AFJ-24S User Manual
75
4.2
How To Load The Sheet Media Into Machine Without Auto Feeder
To load the media properly, please follow the procedures listed below:
Step 1
Use the lever on the upper right side of the cutting plotter to raise or lower down pinch rollers. Pull the
lever forward until it makes a clicking sound then the pinch rollers are raised.
Step 2
Load your media on the platen and slide it under the pinch rollers from either the front side or the backside.
The
alignment rulers
on the platen extension will help you to adjust the media precisely.
Step 3
Then move the pinch rollers manually to the proper position. Be sure the pinch rollers must be positioned
above the grid drum. The
white marks
on the top trail will remind you where the grid drums are.
Note:
Be sure that the media must cover
the paper sensors on the platen
when loading the media. At least one
of the two paper sensors should be
covered. Once the media covers the
sensor, the cutting plotter will size the
media width and length
automatically.
Paper sensors
Lever
White marks
Summary of Contents for AFJ-24S
