3 - 8 • Using Windows 3.1
• You need to change the Virtual Memory setting when you add RAM to the
printer or if you routinely download fonts to the printer’s memory. The figure
sets the amount of virtual memory that will be available for printing. The
amount of memory that can be allocated depends on the amount of RAM
installed in the printer.
Full instructions on how to change this figure are included in the Adding RAM
section of this manual.
Port assignment – Windows 3.1
You may need to change the port used by your PC; your PC’s LPT1 may be used by
another device or you may wish to use a serial port. (GCC recommends that you use
one of the LPT [parallel] ports, because they are considerably faster than a serial
port.)
If you want to change the port assignment:
1.
In the Printers dialog box, select the GCC Elite XL 20ppm printer driver in
the “Installed Printers” list box (if it is not already selected).
2.
Click Connect. You will see the Connect dialog box.
3.
Select the new printer port assignment in the “Ports” list box. If the
printer is connected to a parallel interface, select one of the parallel ports
(labeled LPT1, LPT2, etc.). If the printer is connected to a serial interface,
select one of the serial ports (labeled COM1, COM2, etc.).
Summary of Contents for Elite XL 20ppm
Page 1: ...USER S MANUAL GCC TECHNOLOGIES EliteTM XL20ppm ...
Page 168: ...A 5 G H F Skew 2 0mm 0 0787in E 2 0mm 0 0787in E F G H 245mm Paper feed direction ...
Page 172: ...A 9 Squareness 1 3mm 0 0512in J 1 3mm 0 0512in K L M 210mm M L Paper feed direction K J 90 ...
Page 187: ...D 3 On Line Comm Paper Servic e ...
