Jaguar IV User Manua
l
To activate the Die Cut function, go to “Option”, tick “Die Cut”, and enter the amount you wish
for the “Length” and “Force” of both Die Cut and Kiss Cut, then click “OK” (see figure 19).
Figure 4-20
When the job is completed and you untick the Die Cut function, you will be able to adjust the
pen speed, pen force, and offset in the section on the top following normal operating
procedures (see figure 20).
Note:
1. The extension of the blade has
to be set to cut through both the
top layer and the backing in the
very beginning. You then adjust
the tool force for the best cutting
performance.
2. Once the Die Cut function is
activated, it will perform on all the
line segments on the object.
Figure 4-21
The length setting for the
cutting line of Die Cut is in the
range of 0-2000mm whereas
that of Kiss Cut is 0-100mm.
*Note:
Operation
4-11
Summary of Contents for J4-101S
