Jaguar V User Manual
The Control Panel 3-4
Cancel Restore
Change: OK: ENTER
Sure to Restore
Change: OK: ENTER
Die/Kiss Cut:
Length: 9.0 / 0.2 mm
Die/Kiss Cut:
Force: 450 g 45 g
Offline For System Setup
OverCut: 0.00~1.00mm with an
increment of 0.05mm
[ TOOL SELECT]
1S:72 F:80 O:0.275 M
Select: OK:ENTER
OverCut: 0.00mm
Select: OK:ENTER
Set Smoothing Cut
Select: OK:ENTER
Set Tangential Mode
Select: OK:ENTER
Pouncing 0 mm
Select: OK:ENTER
Panel Setup
Select: OK:ENTER
Pouncing: 0~200mm with an
increment of 1mm
Factory Default ?
Select: OK:ENTER
[ MISC]
Enabled, Disabled
Auto Unrolled Media
Select: OK:ENTER
Rear Paper Sensor
Select: OK:ENTER
Enabled, Disabled
Vacuum
Select: OK:ENTER
Enabled, Disabled
First Back To Origin
Select: OK:ENTER
DHCP
Select: OK:ENTER
Enabled, Disabled
IP Address
Select: OK:ENTER
IP Address set, Submask set,
Gateway set
MAC Address
00:CF:52:72:03:01
Enabled, Disabled
AAS Offset
Select: OK:ENTER
Paper Saving Mode
Select: OK:ENTER
Set communication
Select: OK:ENTER
Select Language
Select: OK:ENTER
Firmware x.x.xx
FPGA: xx.xx
Both Expanded Mode, Length Expanded Mode,
Width Expanded Mode, Both Un
e
xpanded Mode,
English, Francais, Türkce, Polski, Japanese,
Deutsch, Italian, Espanol
AAS Copy
Select: OK:ENTER
Enabled, Disabled
Section Cut
Select: OK: ENTER
OFF
Change:
OK: ENTER
ON
Change:
OK: ENTER
Die/Kiss Cut: ON
Select: OK:ENTER
