Jaguar V User Manua
l
Operation
4-3
Step 8
Adjust the two dancer bars to the position between
sensors by loose or tighten the paper roll.
(Figure 4-8)
4.2 Adjust the Plotter
To load the media properly, please follow the procedures listed below:
Step 1
Use the lever on the upper right side of the cutting plotter to raise or lower down pinch
rollers. Pull the lever forward until it makes a clicking sound then the pinch rollers are raised
(
Figure 4-9
).
Step 2
Load your media on the platen and slide it under the pinch rollers from either the front side or
the backside. The
alignment rulers
on the platen extension will help you to adjust the media
precisely.
Note:
Be sure that the media must
cover the paper sensors on the
platen when loading the media.
At least one of the two paper
sensors (Figure 4-10) should be
covered. Once the media covers
the sensor, the cutting plotter will
size the media width and length
automatically.
Paper sensors
Figure 4-10
Lever
Figure 4-9
Figure 4-8
Dancer bar
Sensor
