Puma III User Manual
Basic Maintenance
6-2
6.2 Cleaning the Grid Drum
Turn off the cutting plotter, and move the tool carriage away from the area
needed to be cleaned.
Raise the pinch rollers and move them away from the grid drum for
cleaning.
Use a bristle brush (a toothbrush is acceptable) to remove dust from the
drum surface. Rotate the drum manually while cleaning. Refer to Figure 6-1
6.3 Cleaning the Pinch Rollers
If the pinch rollers need a thorough cleaning, use a lint-free cloth or cotton
swab to wipe away the accumulated dust from the rubber portion of the pinch
rollers. To prevent the pinch rollers from rotating while cleaning, use finger to
hold the pinch rollers not to rotate.
If needed to remove the embedded or persistent dust, use the lint-free cloth or
cotton swab moistened with rubbing alcohol.
Figure 6-1
Note:
The daily maintenance of your cutting plotter is very important.
Be sure to clean up the grid drum and pinch rollers regularly for
better cutting accuracy and output quality.
Summary of Contents for P3-60
