Puma II User’s Guide 2-9
2.5 Media Loading
2.5.1 Loading the Sheet Media
To load the media properly, please follow the procedures listed below:
1. Pull the lever forward to raise the pinch rollers (Figure 2-13).
Load your media on the platen and slide it under the pinch rollers from either the front
side or the backside. The
alignment rulers
on the platen extension will help you to
adjust the media precisely.
Note:
Be sure that the media must cover the paper sensors on the
platen when loading the media. At least one of the two paper
sensors (Fig 1-1) should be covered. Once the media covers the
sensor, the cutting plotter will size the media’s width and length
automatically.
Figure 2-13
Summary of Contents for PII-132S
Page 1: ...Puma II users manual...
