Puma II User’s Guide 2-19
2.9 ON/OFF LINE Key
**On - line
When the machine is in “
ON LINE
” condition. The ON/OFF LINE LED is on. The cutting
plotter is ready to receive data from the host computer. At this moment, only “PAUSE”
and “ON/OFF LINE” keys are valid.
**Change the setting value
1. Press
the
PAUSE key.
Then switch the dip to
change the setting value
.
2. Press
the
ON/OFF LINE key
to effect new setting and
continue cutting
.
Note :
The parameters of dip switch can not be changed while the cutting has started
unless pressing the “
PAUSE
” key. When press the “
PAUSE
” key, you can change
the setting.
**
Terminate the cutting & clear the data in the buffer
1.
Press
the
ON/OFF LINE
or
PAUSE
key
2.
Then press the
DATA CLEAR
key
**Off - line
When the machine is in “
OFF
LINE
”
condition
,
the
ON/OFF LED
turn off. At this
moment, you can switch dip setting, make cutting test to adjust blade pressure and set
new origin. Press the key again will let the cutting plotter switch back to “ON LINE”
condition, and resume the suspended operation. But there might be some data loss during
this interruption.
2.10 PAUSE Key
The purpose of the “
PAUSE
” key is to temporarily terminate the motion of the cutter after
it started cutting. At this moment, the
ON/OFF LINE LED
flash; you can change the dips
switch setting and the cutting force. It will resume cutting after pressing the
ON/OFF
LINE
key
to make the machine in on-line status.
2.11 Repeat Key
You can cut your last cutting job at the same position by pressing
REPEAT
key without
setting new origin. If you’re using a thicker media, it is better to use this function to avoid
Summary of Contents for PII-132S
Page 1: ...Puma II users manual...