DU-WMM-0001 Rev B 4/12/07 GCX Corp. Page 3 of 3
Swivel Fitting
Post
10-32 x 3/8" SHCS (3)
Flexible Cable Covers
Pass-through Slide
Tilt & Tilt Tension
In most configurations, the tilt of the mounted device can be adjusted.
1. Loosen the Adjustment Lever (if included).
2. Grasp the top and bottom of the device and tilt it to the
desired
angle.
3. Tighten the Adjustment Lever (if included).
4. Using a 5/32'' hex wrench, equally tighten or loosen the two (2) Tilt
Tension Screws.
Cable Management
Two cable management features allow convenient placement and flow of
cables:
1. An open cavity beneath the arm with flexible cable covers manages
cables going between front and rear of the arm.
2. A “pass-through” channel slide allows cables to run behind the arm
within the Channel.
Note:
If cable connectors are too large to fit
through the pass-through, try placing the cables in the path of the
Slide before installing the arm in the Channel. Contact GCX for
optional Channel Covers available to further manage the flow of
cables in the Channel.
Attachment of Down Post
Some applications may require a Down Post to mount
module racks or other devices.
Attaching Down Post to Arm
1. Align the screw holes in the Post with corresponding threaded
holes in the Swivel Fitting.
2. Using the 5/32 [4 mm] hex wrench provided, fasten Down Post to
Swivel Fitting with three (3) #10-32 x 3/8" SHCS.
Routine Maintenance
Periodically inspect all fasteners associated with the mounting system. Tighten or adjust fasteners as necessary for
optimal operation and safety.
Cleaning the Mounting Assembly
1. The mounting assembly may be cleaned with most mild, non-abrasive solutions commonly used in the hospital
environment (e.g. diluted bleach, ammonia, or alcohol solutions).
2. The surface finish will be permanently damaged by strong chemicals and solvents such as acetone or
trichloroethylene.
3. Do not use Steel wool or other abrasive material.
4. Damage caused by the use of unapproved substances or processes will not be warranted. It is recommended that you
test any cleaning solution on a small area of the arm that is not visible to verify compatibility.
5. Never submerge or allow liquids to enter the arm. Wipe any cleaning agents off of the arm immediately, using a water-
dampened cloth. Dry the arm thoroughly after cleaning.
CAUTION:
GCX makes no claims regarding the efficacy of the listed chemicals or processes as a means for controlling
infection. Consult your hospital’s infection control officer or epidemiologist. To clean or sterilize mounted devices or
accessory equipment, refer to the specific instructions delivered with those products.
Tilt Adjustment Lever
Tilt Tension Screws (2)
