- 14 -
December 22
nd
, 2022
GDC SR-1000 STANDALONE INTEGRATED MEDIA BLOCK
™
INSTALLATION MANUAL
3.CONNECTING PORTABLE STORAGE/ENTERPRISE STORAGE WITH THE SR-1000
3.2. Connecting the Enterprise Storage
1. Connect the power cord provided in the package to the power connector on the back panel
of the Enterprise Storage (refer to
). The other end of the power cord needs to be
connected to a recommended power outlet (100 to 240V~, 63 to 47Hz, 4.5-2A).
2. Connect one end of the eSATA cable provided in the package to the eSATA port of the
Enterprise Storage and tighten the screw, as shown in
Figure 10: Connect eSATA cable to the Enterprise Storage
3. Connect the other end to the eSATA cable to the eSATA port on the SR-1000 IMB and
tighten the screw, as shown in
Figure 11: Insert eSATA cable into SR-1000 eSATA port
NOTE
:
To use the Enterprise Storage as the content source, it MUST be connected to the
eSATA port of the SR-1000 board.