- 18 -
December 22
nd
, 2022
GDC SR-1000 STANDALONE INTEGRATED MEDIA BLOCK
™
INSTALLATION MANUAL
6. SR-1000 NETWORK SETUP
6. SR-1000 NETWORK SETUP
The SR-1000 Network settings can be accessed from
Configuration
→
System
sub-tab. The IPs
for the IMB network interfaces can be updated by following the steps mentioned below:
1. Login as to the SR-1000 Web UI using
Maintenance
access level.
2. Go to the
Configuration
→
System
→
Network Configuration
section.
3. By default, the
IMB Ethernet 2
is the main IP address of the SR-1000. The Web-UI
interface can be reached at this IP address. The
IMB Ethernet 2
IP Address can be
updated as per the cinema's management network & the subsequent
Subnet Mask
&
Gateway
values need to be entered.
4. As an option; a Secondary
IP address
and
Subnet Mask
for the SR-1000 can be
mentioned by checking the
IMB Ethernet 1
checkbox. This can be used to connect to
the cinema's content network.
5. Once the IP values have been entered, click on the
Validate IPs
button to check
their correctness.
Figure 14: IMB Network Configuration (1)
