- 22 -
December 22
nd
, 2022
GDC SR-1000 STANDALONE INTEGRATED MEDIA BLOCK
™
INSTALLATION MANUAL
8. SERIES 2 PROJECTOR SETUP
8. SERIES 2 PROJECTOR SETUP
To configure a Series 2 projector to play content with the SR-1000, follow the instructions
mentioned below:
▪
IMB Marriage must be done,
▪
Service door tamper must be cleared
▪
The projector must be set up according to the requirements of the projector manufacturer.
8.1. IMB Marriage and Clearing the Service Door Tamper
from the SR-1000
Follow the steps below to perform the marriage between the SR-1000 and to clear the service
door tamper on the SR-1000:
1. Under the
Configuration
tab in the menu, click the
System
sub-tab.
2. Go to
Clear IMB Tampers
section.
3. Click
Marry
to perform the marriage of the projector and the SR-1000.
4. Click
Close
to
clear the door tamper errors with the projector
5. After the IMB marriage is performed and the tampers are cleared; green
‘
Married
’
and
‘
Closed
’
indicators will be shown respectively (as seen in
).
Figure 19: Clear IMB tampers
