16
6.
M
AI NT EN A NC E
D
ET AIL S
WARNING!
Failure to maintain equipment may result in injury or death and/or damage to property and equipment
Recommended maintenance to be performed on the operator and gate are as follows:-
Operator performs over 150 cycles a day
each month
Operator performs between 100-150 cycles a day
every 2 month
Operator performs between 50-99 cycles a day
every 4 months
Operator performs between 20-49 cycles a day
every 6 months
Operator performs under 20 cycles a day
every 12 months
Date: ..............................................................................................
Site Name:..........................................................................................................................................................
Site Address: ......................................................................................................................................................
Before
commencing maintenance on the operator, isolate the electrical supply to ensure operator will not run
inadvertently.
Gate rolls freely when in manual.....................................................................................
Gate wheels and guide rollers in good condition.............................................................
Gate stops in good condition and not loose .....................................................................
Gate rack is tight & correct clearances between pinion wheel & rack ............................
Gate track is not damaged................................................................................................
Gate operator mounting bolts right..................................................................................
No oil leaks from gearboxes ............................................................................................
Gearbox mounting bolts/nuts tight ..................................................................................
Inside operator and control box clean..............................................................................
‘Baygon’ Surface Spray around operator and control box (not on electronics) ..............
All electrical connections tight ........................................................................................
Limit Switches operate in appropriate positions/ chain oiled..........................................
External safety devices work effectively / cleaned..........................................................
Electromagnetic lock, if fitted, operates correctly and is clean .......................................
Wash down of control box and cover (particularly near corrosive/ sea environments.....
General operation i.e. speed, auto close etc normal ........................................................
Comments ............................................................................................................................................
..............................................................................................................................................................
..............................................................................................................................................................
Service performed by...........................................................................................................................
Summary of Contents for GDS 450 W
Page 14: ...14 4 SCHEMATIC WIRING DIAGRAM ...
Page 18: ......
