42
Flight
Pre-check
Check all parts of the aircraft before each flight. Look for cracks in the propellers, cracks in
the arms and make sure that the motors spin freely. If there is any damage, please repair/replace
before trying to fly the aircraft.
Make sure the flight battery is fully charged and that the remote control has a good charge
before attempting to fly the aircraft.
Make sure the arms and landing legs are in their proper places and that the propellers are
properly installed.
Check whether the connection between the remote controller and the aircraft is normal.
Always operate with the latest firmware. And check whether the APP and the remote
controller are connected normally.
Check whether the electric motor and the gimbal are working properly after the aircraft is
powered on.
Make sure that the SD card has been inserted into the camera.
Accelerator calibration
When the aircraft leaves the factory, the accelerometer has already been calibrated. It is suggested
to calibrate it again if the drone has been updated to ensure the safe flight. Follow these steps:
Visit www.gdu-tech.com to download and install the ‘FCS Configuration Adjustion Software’
on your PC.
Make sure the aircraft is sitting on a level surface and POWERED ON. Then connect the
aircraft to your PC, the software will automatically indentify the aircraft.
Open the ‘Accelerometer’ which under the options of ‘Basic’ in the parameter adjustment
software, then click the button that says ‘Click to start the single axis calibration’.
Wait for three seconds and the calibration is finished.
※
It’s recommended to calibrate the accelerator on PC with configuration of Win 7 (64 bit) or higher.
※
Do not power on the remote controller during the whole process.
Compass calibration
Power on the remote control and then the aircraft. At this time, the aircraft will start a
self-check and a series of beeps will sound.
After the beep stops, toggle the “Flight Mode Switch” back and forth for several times.
Summary of Contents for Byrd Advanced
Page 1: ...User Manual GDU Byrd User Manual V1 1 ...
Page 19: ...19 ...