Page 57
NOTICES
(Applies to products which
have the CE mark attached)
Declaration of Conformity
Manufacturer’s Name:
Caddx Controls
Manufacturer’s Address: 1420 North Main Street
Gladewater TX 75647
EU Representative:
Interlogix Europe
Product Identification
Product:
NetworX
Model:
NX-8
Brand:
CADDX
R&TTE Directive
See EMC and LVD tests below
EMC Directive
EN50081-1
EN50130-4
EN55022
EN60950
EN61000-3-2
EN61000-3-3
LVD Directive
EN 60950: 1999-4 3rd edition
Means of Conformity
We declare under our sole responsibility that this
product is in conformity with Directive 1999/5/EC
(R&TTE); Directive 73/23/EEC (LVD); and Directive
89/336/EEC (EMC) and based on test results using
(non)-harmonized standards in accordance with the
Directives mentioned.
Additional Tests
This equipment has been tested and found to comply
with the following standards (which are no longer
required for compliance).
Network Compatibility Declaration
We declare under our sole responsibility that this
product is designed to work with the networks in the
countries marked with a check (
) and may have
interworking problems with the countries that are not
checked. Due to the inherent differences in the
individual PSTNs, certain software settings may need
to be adjusted on a country-to-country basis. If it is
desired to use this equipment on a network other than
the one on which it was originally installed, you should
contact your equipment supplier.
(
)
Austria
(_) Liechtenstein
(
)
Belgium
(
)
Luxembourg
(
)
Denmark
(
)
Netherlands
(
)
Finland
(
)
Norway
(
)
France
(
)
Poland
(
)
Germany
(
)
Portugal
(
)
Greece
(
)
Spain
(
)
Iceland
(
)
Sweden
(
)
Ireland
(
)
Switzerland
(
)
Italy
(
)
United Kingdom
Telecom Approval Notice
This equipment has been approved in accordance with
the Council Decision 98/482/EC for pan-European,
single terminal connection to the public switched
telephone network (PSTN). However, due to the
differences between the individual PSTNs provided in
different countries, the approval does not, of itself, give
an unconditional assurance of successful operation on
every PSTN network termination point. In the event of
problems, you should contact your equipment supplier
in the first instance.
Electrical Requirements
This device automatically adjusts to voltages within the
range of 230 V 50/60 Hz.
Fuse: Type T 200mA 250 VAC
