05-2806A01, Rev. H
iNET Series Reference Manual
33
•
Alarmed
—A alarm event has been logged and not cleared.
•
Operational
—Unit operating normally.
At a Remote:
•
Scanning
—The unit is looking for an Access Point beacon
signal.
•
Exp(ecting) Sync(hronization)—
The unit has found a valid
beacon signal for its network.
•
Hop Sync—
The unit has changed its frequency hopping pat-
tern to match that of the Access Point.
•
Connected
—The unit has established a radio (RF) connec-
tion with the Access Point, but has not obtained cyber-secu-
rity clearance to pass data.
•
Associated
—This unit has successfully synchronized and
associated with an Access Point.
•
Alarmed
—The unit is has detected one or more alarms that
have not been cleared.
NOTE:
If an alarm is present when this screen is displayed, an “A)”
appears to the left of the
Device Status
field. Pressing the “A”
key on your keyboard takes you directly to the “Current
Alarms” screen.
•
Uptime
—Elapsed time since the transceiver was powered-up.
•
Firmware Version
—Version of firmware that is currently active in
the unit.
•
Hardware Version
— Hardware version of the transceiver’s printed
circuit board.
•
Serial Number
—Make a record of this number. It must be pro-
vided to purchase Authorization Keys to upgrade unit capabili-
ties. (See
“
Authorization Keys Menu” on Page 108.)
Summary of Contents for MDS iNET-II 900
