GE Security NetworkX NX-1300E, User Manual

Page 12 

BYPASSING ZONES 

If you wish to bypass one or more zones, this must be done while the system 

is in the disarmed state. The following steps are used for bypassing zones: 

Step 1

Press the [

BYPASS

] key. 

Step 2 

Enter user code, if required (optional).  The 

bypass light

 flashes. 

Step 3 

Enter 1 or 2 digits indicating the zone you wish to bypass, i.e. press 

the [

1

] key for zone 1, press [

1

]-[

2

] for zone 12. 

Step 4 

Press the [

BYPASS

] key again. 

Step 5 

The corresponding 

zone light

 will illuminate indicating the zone has 

been bypassed.  Repeat steps 3 and 4 for any other zone(s) that 

need to be bypassed. 

Step 6 

Press the [

BYPASS

] key again  -or- press the [

#

] key to exit the 

Bypass Mode. The 

bypass light

 will stop flashing upon exiting the 

Bypass Mode. 

GROUP BYPASS 

By pressing the [

BYPASS

] key, followed by the [

0

] key, then the [

BYPASS

] 

key again, all zones that are designated as group bypass zones will be 

bypassed. Press the [

BYPASS

] key again to exit group bypassing. 

UNBYPASSING 

To manually unbypass zones, perform the bypassing procedure on a zone that 

is already bypassed. The corresponding light for that zone will go off when 

unbypassed. 

NOTE: All zones will automatically be unbypassed each 

time the system is disarmed. 

TURNING THE DOOR CHIME ON AND OFF 

The door chime is turned on or off by pressing the [

CHIME

] key while the 

system is in the disarmed state. If the chime is on the 

chime light

 will be 

illuminated. If the chime is off, the 

chime light

 will be off.  Each press of the 

[

CHIME

] key will toggle the chime feature on/off and produce a momentary 

ding-dong sound.