GE Security NetworkX NX-1300E, User Manual

Page 5 

Quick Arm 

An option that allows you to turn on (ARM) the 

security system by pressing either the [

STAY

] or 

[

EXIT

] key on the keypad control (for ARMING only) 

as programmed by the installing company. 

User Code 

A four (4) or six (6) digit entry code used to arm or 

disarm the system. 

UNDERSTANDING THE LIGHTS 

ARMED LIGHT 

The 

armed light

 is “on” when the system is armed.  The 

armed light

 is “off” 

when it is disarmed.  The 

armed light

 will flash when there has been an 

alarm during the previous arm cycle. 

BYPASS LIGHT 

The 

bypass light

 is “on” when any zone in this keypad’s partition is 

bypassed. The zone(s) that is bypassed will also be illuminated.  If the 

bypass light

 is “off”, no zones are bypassed. 

CANCEL LIGHT 

The 

cancel light

 will flash during an abort delay time.  If a code is entered 

followed by the [

CANCEL

] key while this light is flashing, all abortable 

reports will stop the communication process. 

Note: The abort feature 

must be enabled

. Entering a code followed by the [

CANCEL

] key during or 

after an alarm report to the central station will cause the 

cancel light

 to 

come on. It will stay on until the central station has received the cancel 

report. 

Note: The cancel feature must be enabled. 

CHIME LIGHT 

The c

hime light 

is “on” when the chime feature is “on”;  “off” otherwise. 

EXIT LIGHT 

The 

exit light 

is “on” during the exit delay. Please note that the light will 

flash during the last 10 seconds of the exit delay as a warning that the time 

is running out.  (The user may want to disarm the system if the 

exit light

 is 

flashing in order to prevent an alarm. The user may then re-arm the system 

and exit before the delay expires.) 

FIRE LIGHT 

A steady 

fire light

 means a fire zone has been faulted. A rapidly flashing 

fire 

light

 means that a fire zone is in a trouble condition.