NX-592E-GSM Wireless Gateway
Installation Manual
10
Programming using the keypad
The wireless gateway needs to know the address of at least one of the LCD keypads. Some commands, such as
getting the zone names for display on the website, will not work if the keypad address is not known. By
default, the wireless gateway assumes a keypad address of 192 (keypad 1, partition 1). If your LCD keypad is
programmed differently (press
*94
+
installer code
to check), you must change the wireless gateway keypad
address. To change the gateway keypad address, do the following:
1. Press
*
, then
8
.
2. Enter the “Go to program” code (the default code is
9
,
7
,
1
,
3)
. If the code is valid, the keypad display
will prompt you for a device address.
3. Enter the address of the NX-592E (
7
,
8)
then press
#
. At this point, the keypad display will prompt you
for a programming location to be entered.
4. Enter
0
, followed by the
#
key. Location 0, which is the LCD address will display. The default is
192
.
For a list of addresses, see
Table 4
.
5. To change the LCD keypad address, enter the new address, followed by the
*
key. The display will
return to the location prompt.
6. To exit this location without changing the data, press the
#
key.
7. To review the data, repeat the above procedure, pressing the
*
key without entering data first. If you
attempt to program an invalid entry for a particular segment, the keypad sounder will emit a triple error
beep (beep, beep, beep) and remain in that segment waiting for a valid entry.
8. Press the
Exit
key to exit this programming level. Press the
Exit
key again to exit Program Mode.
While in programming mode and not in a location, the number in parentheses is the location you were
previously changing. For example, if the display reads
Enter location, then # (2)
, it is reminding you that
location 2 was the last location you programmed.
Location 0: LCD keypad address
Certain commands in the module require it to know the location of at least one LCD keypad (if one exists in the
system). If your system has an LCD keypad we recommend that you place it in Partition 1 Keypad 1. This will
allow Location 0 to be left at the factory default. If the LCD keypad is selected as something other than
Partition 1 Keypad 1, program the appropriate address in Location 0. Table shows the address options.
Table 4.
Addresses
Keypad
Part 1
Part 2
Part 3
Part 4
Part 5
Part 6
Part 7
Part 8
1
192
193
194
195
196
197
198
199
2
200
201
202
203
204
205
206
207
3
208
209
210
211
212
213
214
215
4
216
217
218
219
220
221
222
223
5
224
225
226
227
228
229
230
231
6
232
233
234
235
236
237
238
239
7
240
241
242
243
244
245
246
247
8
248
249
250
251
252
253
254
255
