GE 14, Use And Installation Manual

Light Bulb Replacement

A light bulb and socket are located at the top of the fresh food compartment
just behind the temperature control panel. To replace the bulb, unplug the
refrigerator from its electrical outlet, unscrew the bulb when cool, and
replace with same size bulb.

Drawer and Cover Removal

Drawers will stop before coming all the way out of
the refrigerator, to help prevent contents from spilling
onto the floor. These drawers can be removed easily
by grasping the sides and lifting up slightly while
pulling drawers past the “stop” location.

Full-Width Drawer with Plastic Cover

(on some models)

To remove the cover, lift it off 
its supports, pull it forward, 
tilt it and take it out.

CARE AND CLEANING 

(continued)

10

Behind Refrigerator

Be careful moving your refrigerator away from the
wall. All types of floor coverings can be damaged,
particularly cushioned coverings and those with
embossed surfaces. 

Turn the leveling legs at each front corner of the
refrigerator counter-clockwise until the rollers support
the refrigerator; then pull the refrigerator straight out 

and return it to position by pushing it straight in.
Moving your refrigerator in a side direction may result
in damage to your floor covering or refrigerator.

After rolling the refrigerator back into place, turn the
legs clockwise until the legs again bear the weight of
the refrigerator.

Twin Drawers with Glass Cover

(on some models)

To remove the glass cover:

1. Remove the drawers.

2. Reach in, push the front of 

glass cover up and, at the
same time, pull it forward as
far as it will come. 

Tilt it and take it out. Avoid  
cleaning the cold glass cover
with hot water because the
extreme temperature difference
may cause it to break.

3. Remove the drawer frame. (Always remove the

glass cover before you take out the drawer frame.)

Lift the frame off the supports at each side and back,
pull it forward, tilt it and take it out.

To replace the glass cover:

1. Lower the frame until it rests on the supports at

each side and back.

2. Replace the glass cover, pushing its rear edge

firmly into the rear frame channel and gently
lowering the front into place.

3. Replace the drawers.