Customer Service
Troubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
Connect the Tubing to the Refrigerator
Before making the connection to the
refrigerator, be sure the refrigerator power
cord is not plugged into the wall outlet.
We recommend installing a water filter if your water
supply has sand or particles that could clog the
screen of the refrigerator’s water valve. Install it in
the water line near the refrigerator.
Remove the plastic flexible cap from the water
valve (refrigerator connection).
Place the compression nut and ferrule (sleeve)
onto the end of the tubing as shown.
Insert the end of the copper tubing into the
water valve refrigerator connection as far as
possible. While holding the tubing, tighten the
fitting.
Fasten the copper tubing into the clamp
provided to hold it in position. You may
need to pry open the clamp.
One of the illustrations below will look like the connection
on your refrigerator.
4
3
2
1
Turn the Water On at the Shutoff Valve
Tighten any connections that leak.
Replace the access cover and screws (on some
models).
2
1
Plug In the Refrigerator
Arrange the coil of copper tubing so that it does not
vibrate against the back of the refrigerator or against
the wall.
Push the refrigerator back to the wall.
Start the Icemaker
Set the icemaker feeler arm to the
ON
(down)
position. The icemaker will not begin to operate
until it reaches its operating temperature of 15°F
(-9°C) or below. It will then begin operation
automatically if the icemaker feeler arm is in the
ON
(down) position.
NOTE:
The icemaker may double-cycle when it
first starts, causing some water spillage from
the icemaker into the ice bucket. This is normal
and should not happen again.
17
1/4
″
Compression Nut
1/4
″
Copper
Tubing
Ferrule (sleeve)
Tubing Clamp
Refrigerator
Connection
1/4
″
Compression
Nut
1/4
″
Copper
Tubing
Remove screws
and fold back
access cover.
Ferrule
(sleeve)
Tubing Clamp
Refrigerator
Connection
OR
