INSTALLATION INSTRUCTIONS
PREPARE THE OPENING (cent’d)
Under the Range
range, like many other household
items, is heavy and can
into soft
floor coverings
as cushioned vinyl or
carpeting.
When
the range on this type
of flooring, use care, and follow these simple and
inexpensive instructions.
The range should be installed on a 1/4 inch thick
sheet plywood (or similar material) as follows:
When the
covering ends
the front of the
range,
the area that the range will rest on should
be built
with plywood to the same level or
higher than the floor covering. This
allow
the range to
moved for cleaning or servicing.
STEP 2
PREPARE FOR ELECTRICAL CONNECTION
Use only a 3-conductor, or if required a
conductor range cord set as noted below. These
cord sets
provided with ring type terminals.
The electrical rating
cord must be 125/250
minimum,
amperes.
Only a 4-conductor cord is to be used
when
appliance is installed in mobile home
or where
codes do not permit grounding
through the neutral.
STEP 3
Locate connector block at the bottom rear of
range and remove rear wiring cover.
2. Directly below the connector block is a hole
with a knockout ring for accommodating
Brackets provided are used to support
flexible cord strain relief, which must
securely attached the cord set.
STRAIN
BRACKETS
WITH RANGE CORD
)
STEP
3-WIRE SYSTEM
Cord
Installation-Insert
through power cord terminals so that the
pass through connector
terminals and
engage nuts. Tighten screws
POWER CORD
RING TERMINAL
POWER
CORD
CONNECTOR
BLOCK
TERMINAL
--
Cable Direct
between the connector block terminals
movable nuts with screws tightened securely,
1. Copper
SCREW
CONNECTOF?
TERM IN Al-
Connect the neutral or grounded wire of
supply circuit to the neutral terminal
connector block. located in the center.
power leads must be connected to
outside
(brass colored) terminals.
NEUTRAL
TERMINAL
NG
STRAP
ING TO
GE)
APPROVED
COPPER
