GE 164 D2966P073, Use And Care Manual

2. 

Aluminum 

A. 

Connect length 

 building wire to

 terminal block.

 copper wires to aluminum wiring using

special connectors designed and 

 approved

for joining copper   aluminum, and follow the
connector 

 recommended

procedure closely.

 used, location and enclosure of

splices, 

 must conform to good wiring

practice and 

 codes.

STEP 

 SYSTEM

SPECIAL GROUNDING INSTRUCTIONS

WARNING:

 grounded to neutral of appliance

through a link. If 

 in a MOBILE HOME or

if LOCAL 

   not permit grounding

through the neutral:

1) disconnect the link from neutral,

 use grounding terminal or lead to ground

unit in accordance with local codes, and

 connect 

 terminal 

0

1

- 

 to branch

circuit in usual manner.

 appliance is to be connected 

means   a 

 set, use 

 cord

for this p

CO 

LUG

STEP 

 BRACKET INSTALLATION

 bracket is supplied with instructions

for installation in   

   locations. The

instructions include a template,   parts 

 and a

   tools necessary’ to 

 installation.

Read 

 IMPORTANT 

 INSTIKJCTIONS

 the instructions that fit your situation 

WARNING

1. 

Range must be secured by ANTI-TIP bracket

supplied.
2. See instructions to install (supplied with

bracket).
3. 

 properly installed, range could be

tipped by stepping or sitting on door. Injury
might result from spilled hot liquids or from
range itself.

Typical installation of Anti-Tip bracket

Attachment to Wall

Bracket

STEP 7
LEVELING THE RANGE

The range must be level. Leveling feet are located

at each corner of the base of the range. Remove
the storage drawer or kick panel (depending on

your model) and using channel locks, rotate the

 feet in and out as required to 

 the

range. (For instructions on how to remove and
replace the storage drawer or the kick panel, see
the Cleaning 

 the Range section in Care

and Cleaning.) On some models, there are 
covers which may be removed for easy
adjustment (just squeeze and pull).
One   the rear leveling feet will engage the

ANTI-TIP bracket (allow for some side to side

adjustment). Allow a minimum clearance of 
inch between the range and the leveling foot that

is to be installed into the ANTI-TIP bracket.

Check the range for proper installation into the
ANTI-TIP bracket (after the range has been

properly installed) by removing the kick panel or
storage drawer and inspecting the rear leveling

 Make sure it fits securely into the slot.

STEP 8
FINAL 

Be sure all switches are in the 

 position

before leaving the range.

35