13
Consumer
S
uppor
t
Operating
Instructions
Safety
Instructions
Car
e
Instructions
Tr
oubleshooting
Tips
Problem
Possible Causes
What To Do
Dishwasher won’t run
Fuse is blown, or the
•
Replace fuse or reset circuit breaker. Remove any other appliances
circuit breaker tripped
from the circuit.
Power is turned off
•
In some installations, the power to the dishwasher is proved through a
wall switch, often located next to the disposer switch. Make sure it is on.
Reboot your control
•
Turn off power to the dishwasher (at circuit breaker or wall switch) for
30 seconds, then turn back on.
Steam
This is normal
•
Steam comes through the vent during washing, drying and when
water is being pumped out.
Control panel
Door latch may not be
•
Make sure the door is firmly closed.
responded to input
properly seated
but dishwasher never
filled with water
Water valve may be
•
Make sure water valve (usually located under the sink) is turned on.
turned off
Dishwasher beeps
This is normal
•
Close the door after opening it mid-cycle.
once every 15 seconds
This is a reminder that the
•
Press ON/OFF to turn OFF the dishwasher.
door has been left open
during operation
Beeping at the end
This is normal
•
The dishwasher will beep and the CLEAN light will display at the end
of the cycle
of the wash cycle.
LOW RINSE AID
Rinse aid dispenser
•
This can only be turned off by filling the rinse aid dispenser with
Jet-Dry
®
light is on
needs to be refilled
or
Cascade Crystal Clear
®
.
See Refilling the Rinse Aid Dispenser section.
ge.com
