11
H
ANDSET
S
OUND
S
IGNALS
Signal
Meaning
One beep every 7 seconds
Battery is low
Three long beeps (with ringer on)
Page signal.
A long warbling tone (with ringer on)
Signals an incoming call.
One long beep
Handset and Base are
not communicating: the handset
might be too far away from the base,
you might need to try another
channel, or the base might not be
receiving power.
T
ROUBLESHOOTING
G
UIDE
In case of difficulty, please check the following Troubleshooting Guide
before seeking service.
Problem
Solution
No dial tone
• Check installation:
— Is the base power cord connected to a working
outlet?
— Is the Phone-in-Use light on?
— Is the telephone line cord connected to the base
unit and the wall jack?
• Disconnect the base from the wall jack and connect
another phone to the same jack. If there is no dial tone
in the second phone, the problem might be your
wiring or local service.
• Is the handset out of range of the base?
• Make sure the battery is properly charged (12 hours).
• Is the battery pack installed correctly? See page 8.
• Did the handset beep when you pressed the phone
button? Did the Phone-in-Use light come on? The
battery may need to be charged.
• Reset the security code by placing the handset in the
base for about 20 seconds.
2-9763A CAN IB E O
4/7/97, 10:39 PM
11
