Installation Instructions
25
REMOVING THE FREEZER DRAWER
(on some models)
REMOVE THE BASE GRILLE
(if needed)
If, after removing the freezer drawer and
refrigerator door, the refrigerator will still not fit
through a doorway, the base grille can be
removed.
Remove the 2 Phillips-head screws on either
side of the base grille.
Pull the grille straight out.
3
The freezer drawer can be removed, if needed, to fit
through tight areas.
Read these instructions completely and carefully.
REMOVE THE DRAWER FRONT FROM
THE SLIDES
Remove the hex-head screw from each side
of the rail assembly.
Tilt the drawer front toward the refrigerator
and lift out.
Set the drawer front on a non-scratching
surface.
Push the rail assemblies back into the cabinet.
2
A
A
C
D
B
Rail
assembly
Screw
B
REMOVE THE BASKET
Open the freezer drawer until it stops.
Lift the freezer caddy up
.
Pull the divider forward until the rear locating tabs
are out of the slots. Turn the divider slightly to the
side to release the front locating tabs and lift out.
The freezer basket rests on the metal slide
brackets and is held in place with swing locks.
Turn the swing locks from vertical to horizontal
position. Open refrigerator doors.
Lift the basket up and rotate it toward you.
Slide out from the side of the drawer.
1
A
D
E
B
C
F
A
