12
Using Your Remote, cont.
Volume Feature.
3. Press and release the
MUTE
button.
4. Press and release the
VOL button
.
The red indicator light will blink twice
and go off.
Code Identification
1. Press and hold the
SETUP
button
until the red indicator stays on
(approximately 4 seconds) and then
release the button.
2. Press and release the desired device
button (
TV, DVD, CBL/SAT, DVR/AUX
)
you would like the code for.
3. Press and release
ENTER
button.
4. Press and release the
#1
button.
Count the number of times the
remote light flashes. This is the
number corresponding to the first
digit of the code. Repeat the process
by pressing the
#2, #3
and
#4
buttons for the remaining digits.
5. Press and release
ENTER
button to
exit this mode.
Reset to Factory Settings
1. Press and hold the
SETUP
button
until the red indicator stays on
(approximately 4 seconds) and then
release the button.
2. Press and release the
MUTE
button.
3. Press and release the number
#0
button. The red indicator light will
flash twice.
Summary of Contents for 20621
Page 43: ...43 Notes ...
