GE 20673, User Manual

Operation Instructions

14

+

-

+

-

AAA

AAA

REMOTE CONTROL OPERATIONS

Step 1. 

Restore power at circuit breaker and turn the wall switch to the on 

position (if using wall switch) to test for proper operation, 

Step 2. Open the battery compartment cover, and then install two 1.5-volt 

AAA  batteries  (KK)  provided  in  the  remote  control  bag.  Ensure  the 

batteries are installed correctly with regard to polarity (+ and -). 

Step 3.  Check “ O " and " I " dip switch: For this fan the dip switch should be 

in the “I” position, allowing for dimming of the light.  Place the switch in the 

“0” position to turn the dimming feature off if you do not want the dimming 

feature.

Step 4. Close the battery compartment cover and see below diagram for the 

function of each button on the transmitter.

Step 5. Select a location to install the transmitter holder (JJ), Mount the 

transmitter holder (JJ) using the wood screws (LL) provided. 

"Sync" switch:

 “ O " and " I " dip switch 

This button turns the fan ON or OFF.

"    " 

button

This button delays the light turning off 

for approximately 5 seconds, enabling 

you to exit your room before the light 

turns completely off.

 "    " button

This button controls the light and also

controls the brightness setting. Press and

release the button to turn the light ON or OFF.

Press and hold the button to set the desired

brightness: the light will slowly illuminate to 

maximum light output and then stop when 

holding the button, then release the button 

and hold it again until it reaches minimal 

illumination where it will automatically stop 

again. The light button has an auto-resume, 

it will stay at the same brightness as the 

 last time it was turned off. 

 Low speed

Medium speed

 High speed

Note :

.

To prevent damage to transmitter, remove the batteries if not used for long periods.

.

Replace batteries as a simultaneous set – always replace the whole set of batteries at one time, taking care not to mix old and new ones, or batteries of 

different types.

.

Please contact your local batteries recycling center for proper battery disposal information.

Operation indicator

IMPORTANT

: If the remote control  is not operating correctly, please follow 

the steps on page 16, item 5 for syncing the switch. Use the corner of the 

battery cover to press the “Sync” switch for syncing function. 

Note

:  This Fan and Remote has a dimming function for the light. You can 

control the brightness of the light with the                        on the hand held 

remote. Please see below for Remote Functions.

 "    " button

REMOTE FUNCTIONS