Operation Instructions
15
FAN REVERSE FUNCTION
The reversible motor provides upward and downrod air flow for desired air circulation to save energy, see below
for the details.
FCC ID: 2AAZPFAN61T3SP
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1.
This device may not cause harmful interference, and
2.
this device must accept any interference received, including interference that may cause undesired operation.
CAUTION:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
rease the separation between the equipment and the receiver.
rcuit different from that to which the receiver is connected.
TV technician for help.
Warm weather - Switch to the “Forward”
position: A downward air flow creates a
cooling effect as shown. This allows you
to set your air conditioner on a higher
setting without affecting your comfort.
Cool weather - Switch to the “Reverse”
position: An upward air flow moves warm
air off the ceiling as shown.This allows you
to set your heating unit on a lower setting
without affecting your comfort.
The reverse switch is located on the light
kit housing, remove the shade to access
the switch. Slide reverse switch to change
fan rotation.
Note:
wait for fan to stop before reversing
the direction of the blade rotation.
