GE 24962, Instruction Manual

10

  Using Your Remote

Controlling Devices with Separate 

Power On and Off Buttons

Some GE, RCA and ProScan models require 

you to press the device button for more than one 

second to turn the device on and the 

POWER 

button to turn the device off.

Controlling Combo Devices

Some Combo devices (e.g., TV/DVR, TV/DVD, 

DVD/DVR, etc.) will require you to set up two 

different Mode buttons to control both parts of the 

Combo device. For example, if you have a TV/

DVD Combo, you might need to set up one code 

under the 

TV 

button to control the TV part AND a 

separate code (under any other Mode button) to 

control the DVD part.

DVR/DVD Punch-Through

This remote allows the 6 DVD/VCR transport 

buttons (i.e. PLAY, PAUSE, STOP, FF, REWIND, 

and REC) to Punch-through from any Mode 

programmed with TV, SAT or Cable codes to the 

last DVD, or VCR programmed Mode you used, 

i.e., the transport keys control your DVD or VCR 

player even when you are in TV, SAT or Cable 

mode. If you use a SAT/DVR, Cable/DVR, etc., you 

may want to disable this Punch-through feature 

to allow the transport keys to control your DVR 

device. The following steps will disable the punch-

through feature: 

1.  Press and hold 

SETUP 

until the red indicator 

stays on, then release the 

SETUP 

button. 

2.  Press and hold 

PAUSE 

until the red indicator 

turns off, then release the 

PAUSE 

button. The 

PAUSE 

button needs to be held held for about 

3 seconds before the red indicator turns off. 

The punch-through feature can be enabled again 

by repeating the above steps.