GE 24962, Instruction Manual

3

Battery Installation

1.  On the back of the remote, push down on the 

tab and lift the cover off.

2.  Match the batteries to the + and - marks inside 

the battery case, then insert 2 AAA Alkaline 

batteries.

3.  Press the battery cover back into place.

Battery Saver

Your remote automatically turns off if the buttons 

are depressed more than 30 seconds. This will 

save your batteries should your remote get stuck in 

a place where the buttons remain depressed (e.g., 

between the sofa cushions).

Code Saver

You will have up to 10 minutes to change the 

batteries in your remote without losing codes you 

have programmed. However, do not press any 

buttons until batteries are installed in the remote. 

If buttons are pressed without batteries in the 

remote, all codes will be lost.

Code Setup

The 

SETUP

 button is used to setup the remote. 

You can either setup the remote using the code 

for your brand of product, from the code tables (on 

separate sheet), or you can search through the 

library of codes until you find a code that works for 

your product. Please refer to “Code Search” page 

8 for more information on using the code search 

feature to learn how to search through the library 

of codes for your products. NOTE: You can store 

any kind of code under any mode (except TV). I.e., 

you can store a DVR code under the 

SAT/CBL 

button, or a cable code under the 

DVD 

button, etc. 

However, you can only store TV codes under the 

TV 

button.

  Setup