PREPARATION
(continued)
Refrigerator Location
Clearances
not install refrigerator where temperature will
Allow the following clearances for ease of
below
because it will not run often enough
installation, proper air circulation and plumbing
maintain proper temperatures.
and electrical connections:
Do install it on a floor strong enough to support it
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
fully loaded.
Top . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1“
Also
Energy-Saving Tips.
Back . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . “
refrigerator is to be
against wall on the
side.
clearance.
Rollers/Leveling Legs
Some models have adjustable
rollers that allow you to move
the refrigerator
from
cleaning: other
adjustable leveling legs.
Rollers or
should
so the
refrigerator is
on
and
raised just
that
when
Turn the
front
adjusting
or four
i legs
clockwise to raise
to
When adjusting rollers or
leveling legs for proper door
closure, we recommend that the
bottom front edge the cabinet be
approximately
from the
If your refrigerator has a
base grille, you
turn the
adjusting screws through
openings in the grille.
If you would rather remove the
base grille,
the bottom the
and pull out.
To replace the base grille, line up
the clips on the back of the grille
with
openings in the baseplate
and
the
forward
it
into place.
Water Supply to
an
or if you plan to add an
later,
have to be connected to a cold water line. A water supply kit
copper tubing, shut-off valve, fittings and instructions is available
at
cost from your dealer. There should be sufficient tubing for the
from
supply to allow you to move the refrigerator out
from the
feet (approximately 9 feet of 1/4” copper tubing in three
()” diameter
-
).
Summary of Contents for 25
Page 18: ...NOTES 18...