27
Storing a Redial Number
1. Make sure the phone is
OFF
(not in TALK mode).
2. Repeat step 1 through 6 in Storing a Name and Number in Memory.
3. Press redial to display the redial number and name.
4. Press memory/conference again to confirm.
NOTE :
If the number you want to redial has more than 24 digits, the
telephone number cannot be stored in memory.
Inserting a Pause in the Dialing Sequence
Press the #pause button on the touch-tone pad twice to insert a delay in the
dialing sequence of a stored telephone number when a pause is needed to
wait for a dial tone (for example, after you dial 9 for an outside line, or wait for
a computer access tone.) Each pause counts as 1 digit in the dialing sequence.
Reviewing, Changing or Deleting Stored Names/Numbers
To Review:
Press memory/conference on the handset or on base, then press
the caller ID (rev or skip) button (on base) or the caller ID/vol (- or +) button
(on cordless handset) to scroll through the stored numbers. Or press the
memory location number.
To Change:
Follow the steps under Storing a Name and Number in Memory
except replace the stored name or number with the new information.
To Delete:
Press memory/conference on the handset or on base, then press
the caller ID (rev or skip) button (on base) or the caller ID/vol (- or +) button
(on cordless handset) to scroll to a desired memory.
1. While the entry displays, press delete button on base or del/chan button
on handset to mark the entry for deletion. The display shows
DELETE?
2. Press delete button on base or del/chan button on handset again to
delete the entry.
**DELETED**
is displayed.
