background image

Summary of Contents for 27" DROP-IN RANGE

Page 1: ...tric Drill 1 8 Drill Bit oHand or Saber Saw Tape Measure Straight Edge oPencil NOT_ Remove a_ protective p_ast_ coating _rom doo_ _ rame be_ o_ e _nstaHat_on 30 MIN TRIM SECTION FOR COU POST FORMED OR RAISED FRONT EDGE 21 3 4 CABINET FACE TO REAR OF CUT OUr 28 7 16 MOULDING MAY BE FITTED TO THE OVEN TRIM FOR A MORE CUSTOM APPEARANCE _IF NEEDED BUILD UP SIDES OF CUTOUT TO A MIN OF 1 1 2 TOTAL THICK...

Page 2: ...splash D_mension A in Fig 4 _s greater than I 1 8 _ there wiin be a small gap between the wail and the edge of the backguard This is norn _ and should not I _ visually objecf ionabie See F_gs 3 4 o FIGo 4 This appliance must be supplied with the proper voltage and frequency and connected to an individual properly grounded branch circuit protected by a circuit breaker or fuse having amperage as not...

Page 3: ... local codes If the branch circuit neutral conductor is aluminum see WARNIING note 4 Connect the range red lead to the branch circuit red lead and the range black lead to the branch circuit black lead in accordance with local codes If the residence red and black leads are aluminum conductors see VARNING note 2 Grasp the door at each side and lift up and off the hinges CAUTION When the door _s re_o...

Page 4: ...he hinges The hinge arms must still be in the stop position 6o Slide the door down onto the hinges as tar as it will go and close the door see Fig 5 on previous page You may purchase a Backsplash Kit from yDur GE dealer Order kit JX27RWH white kit JXZTRBK black or kit JX27RAD almond Follow installation instructions in the kit NOTE The backspEash k_t attache _ to the counte_ Pub No 31 10417 229C405...

Reviews: