3
Handset Registration
Accessory Handset (Purchased
Separately)
For accessory handsets (without Base unit), an
auto-registration mechanism is available so the
unregistered accessory handset can be automatically
registered without the need of entering a PIN code.
On the base:
1. Put the base into subscription mode, by pressing
and holding the PAGE button for at least 8 seconds.
2. The DECT indicator light starts flashing. It is now
ready to be associated with a new handset. This
registration mode lasts 90 seconds after pressing
the button. Once the subscription is done, the base
LED flashing is switched off.
On the handset:
1. Make sure your phone is
OFF
(not in talk mode).
2. Press
, navigate to the
Registration
menu, press
to enter.
3. Use
or
to scroll to
Register Handset
.
4. Press
to enter the menu and start the handset
registration.
Wait Base searching 1
”is displayed.
If the handset has located the base, it may
display (depending on EEPROM settings), the base
identification number (RFPI).
5.
Handset Registered
is displayed and the handset
goes back to idle.
6. The DECT indicator light on the Base stops flashing
when a handset has successfully been registered.
If the handset does not locate the base, it goes back to
idle mode. Try again.
If the handset emits a double beep, it means that
the base has reached the maximum number of 5
subscribed handsets.
Auto-registration;
Handsets packed with
the base unit are pre-
registered and ready to use
right out-of-the-box.
NOTE:
When a handset is
associated with a base,
a number is given to the
handset by the base. This
number is displayed on the
handset after the name
and must be used for
internal calls.
NOTE:
A handset can be
registered to only one
base.
Auto-registration;
Handsets packed with
the base unit are pre-
registered and ready to use
right out-of-the-box.
NOTE:
When a handset is
associated with a base,
a number is given to the
handset by the base. This
number is displayed on the
handset after the name
and must be used for
internal calls.
NOTE:
A handset can be
registered to only one
base.
